Goal Zero 10A Charge Controller

10 AMP CHARGE CONTROLLER.

Monitor and regulate solar input for 12V batteries with the 10 Amp Charge Controller.

Designed to integrate seamlessly with Goal Zero solar panels, the charge controller comes with a pre-installed 8mm solar connector and an easy-to-read LED screen.

Equipped with an IP65 rating, the charge controller is weather resistant and dustproof, allowing for protection against the elements when powering off-grid adventures or outdoor equipment.

10 AMP Charge Controller Highlights:.

- Designed to monitor and regulate solar input for 12V batteries.

For solar charging with 100 watts and below, we recommend the 10 Amp Charge Controller.

For solar charging with more than 100 watts, we recommend the 20 Amp Charge Controller.

- Charge Controller comes with an integrated 8mm Goal Zero solar connector.

To connect and charge a 12V battery, you must purchase the Spade to SAE Cable and additional cable adaptors.

We recommend either the SAE to Ring Terminal or SAE to Alligator Clip.

- Will not work with Yeti X Power Supply.

- Measures and Weight:

15.5 x 9.91 x 2.6 cm / 408 g.

Goal zero 10A Charge Controller is a product that corresponds to the Solar panels category within Electricity and smarthome selection at your electronics and computers store, techinn. Wait no more and learn about all the advantages belonging to the community of techinn. What are the advantages of Goal zero 10A Charge Controller? This product is designed specifically to provide good support and entirely based on our passion for electronics and computers.