Digitus RJ45+BNC Cable Tester

The LAN tester makes it easy to identify the correct PIN assignment of 10Base-T, 10Base-2, RJ45/TM11 modular cables as well as 258A, TIA-568A/568B and token ring cables by comparing the outgoing cable end with the corresponding receiving cable end. With the remote tester, you can test cables that are installed at a different location, for instance in wall distributors or patch fields. Easy identification of cabling is guaranteed.


Features:

Future-oriented standards and high-end quality for your network:

- With the cable tester, you can easily check that the network cabling has been done correctly and immediately detect if the Ethernet cable is properly connected.
- In addition to the pure continuity test, it is also possible to check that the two cores have not been mixed up or caused a short circuit - thanks to the remote unit, even with the laying cables already installed.
- Depending on the situation, you can switch between a manual test and an automatic test loop that systematically tests one wire after another and then starts over.
- The PoE tester shows whether the PoE signal is present in a port or network socket and what PoE mode it is - PoE Finder is compatible with PoE af & at standards.
- The test device is suitable for all network cables from CAT 3 and Coax-BNC through CAT 5 and CAT 6 to CAT 7A as well as UAE, TAE and telephone cables and helps e.g. with cable installation for DSL connection.

Specification:

- Product dimensions (main device): 80 x 55 x 25 mm (H x W x D)
- Product dimensions (remote): 80 x 25 x 25 mm (H x W x D)
- Product dimensions (hard shell case): 46 x 180 x 120 mm (H x W x D)

Package content:

- 1 x main device
- 1 x remote device
- 1 x PoE test devices
- 2 x kabel adaptera BNC
- 1 x BNC Stecker Plug / Plug Adapter
- Adapter 3x RJ45 do RJ11
- 1 x User Manual
- 1 x hard shell case