Hunt Arm Magum 5 mm shell

The new arm HUNT for textile wishbone ´MAGNUM´ is an object simple but very technical, built in steel hardened with heat treatment, the line in AISI 316 has an incredible mechanical resistance and 50 HRC hardness.

The hook rod 2mm is TIG welded onto a drilled sphere d.5mm.

Mounted by textiles ligatures, does not allow the water to filter inside the hole of the rubber bands (both small hole and big one), and it´s very important to have a high power rubber bands.

The bends with arm ´Magnum´ will be more hydrodynamic, because the steel sphere 5 mm diameter is so small that, as you can see in the pics, at the maximum tension of the rubber bands, the diameter of the latex in correspondence of the sphere has a little swell.

The arm ´MAGNUM´ allows you to grind the rubber bands after tying, for a friction reduction when firing, and then a real increase of the power and precision of the shooting.

The arm ´MAGNUM´, since it´s made in steel, allows the use of the knife for the replacement of the DYNEEMA used as an arch to be tied to the shaft, without the risk of cutting the loop that comes out the rubber band.

The arm ´MAGNUM´ is very simple and innovative and fixes all the textile wishbones issues.

Its ligth weighs (few gr) is voided by grinding the rubber after tying (the exceed latex is heavier than the wishbone).

The arm ´MAGNUM´, unlike textile loops, fits easily also inside the tiny holes of new generation rubber bands.