Saccon Sport rim brake caliper

Answer of JARI

The fastening screw can be removed and changed to a longer or shorter one, I had to change to a longer one myself.

Kiinnitysruuvin saa irrotettua ja vaihdettua pitempään tai lyhempään, itse jouduin vaihtamaan pidempään.

Answer of Aleksandr

The mounting bolt needs to be pushed inward with a light blow from the thread side, then the brake levers should be brought together and the bolt should be pulled out. When bringing the levers together, do not lose the plastic insert.

The mounting bolt needs to be pushed inward with a light blow from the thread side, then the brake levers should be brought together and the bolt should be pulled out. When bringing the levers together, do not lose the plastic insert.

Answer of Martin

You have to loosen the other screws first to get to the screw in the middle. If it is difficult to squeeze the brake while screwing, you can use cable ties or tape while you work. Good luck.

Du måste lossa de andra skruvarna först så du kommer åt skruven i mitten. Om det är svårt att klämma ihop bromsen samtidigt som du skruvar kan du använda buntband eller tejp under tiden du arbetar. Lycka till.

Answer of jean-françois

Yes, it´s not a question of wheel diameter, but of axle-rim distance... There are 2 models, a short one and a long one... check carefully.. bikeinn only sells the short one..

Oui , ce n'est pas une question de diamètre de roue, mais de distance axe-jante ... Il existe 2 modèles un court et un long ...bien vérifier .. bikeinn ne vend que le court ..

Answer of JARI

The bolts can also be removed, leaving only a hole.

Pultit saa myös pois, jolloin jää vain reikä.

Answer of JARI

For my old bike, these rim brakes fit just right because the brake attachment comes with one bolt in the middle, the long bolt attachment goes to the front fork with the fender attachment, and the brake with a shorter bolt is behind the seat under the seat so that it reaches the rim. Almost everyone only sells rim brakes that are suitable for new bikes, which attach from the side of the brake levers to the bike´s own mounts, but since not all bikes have those clips, where do you attach them.

Minun vanhaan pyörääni nämä vanne-jarrut sopivat juuri oikein koska jarrun kiinnitys tulee yhdellä pultilla keskeltä, pitkän pultin kiinnitys tulee etuhaarukalle lokasuojan kiinnityksen kanssa ja lyhyemmän pultin omaava jarru taakse istuimen alle siten että ylettyy vanteelle. Melkein kaikki myyvät vain uusiin pyöriin sopivia vanne-jarruja joiden kiinnitys tulee jarruvipujen kyljestä kiinni pyörän omiin kiinnityksiin mutta kun kaikissa pyörissä ei ole niitä nippoja niin milläs laitat ne kiinni.

Answer of Aleksandr

This is a kit - front and rear calipers.

This is a kit - front and rear calipers.

Answer of Aleksandr

From the center of the axis size 60 / 81 mm.

From the center of the axis size 60 / 81 mm.